Modern design technology requires the installation of large amounts of expensive refractory for high temperature process. Newly installed refractory require a carefully controlled initial heating. Rapid heating and local hot spots creating stresses which cause severe cracking or worth damages. In most industries it has become widely accepted, the only truly effective means of drying out and heating up refractory is to deploy high velocity burners.
NonFerrous Metals

Newly installed refractory needs a slow, controlled first heating: heated too fast or with local hot spots, it cracks, or trapped moisture turns to steam and causes an explosion. Hotwork International dries out refractory linings with High Velocity Burners that pass large volumes of hot gas over the lining, with a 100:1 turndown for close control in the low range where steaming occurs.
- Even temperature distribution
- Extend Refractory life
- Reduce risk of steam explosion
- Cost effective
- 365 days/year available